Change Language :
Clip-on supports for control cabinet
... for brake resistors & drives ...
The new stainless steel brackets allow igus® stepper motor output stages and brake resistors to be mounted in the control cabinet.
The holder for the stepper motor output stages is attached to the side and mounted flat on a DIN rail. This installation enables particularly space-saving electrical wiring in the control cabinet.
The holder for the brake resistors also helps with installation in the switch cabinet. The mounting clip enables tool-free mounting and removal.
Tech up
- Three drive supports for 12 stepper motor drives
- Two brake resistor supports for four brake resistors
- Easy and tool-free assembly
Cost down
- Support for stepper motor drives suitable for igus® D7, D8, D9
- Support for brake resistors suitable for all igus® products in the category
- Space-saving assembly creates space for other components
Proof
- Particularly light: the stepper motor drive support weighs 145g and the brake resistor support only 180g.
Sustainability
- Lubrication and maintenance-free
Here you can see the brackets mounted
Consulting
I look forward to answering your questions
Daniel Webers+49 2203 9649 7066Write e-mail
Shipping and consultation
In person:
Monday to Friday from 7 am - 8 pm.
Saturdays from 8 am- 12 pm.
Online:
24h
WhatsApp-Service:
Montag – Freitag: 8 – 16 Uhr